The Largest Security-Cleared Career Network for Defense and Intelligence Jobs - JOIN NOW

Military

MOBILE INDEPENDENT TARGET SYSTEM

Hull to Turret Transmitter
Table of Contents
Audio Visual Cue (A/V Cue)
MITS OPERATING AND TROUBLESHOOTING PROCEDURES

1. INSTALL 4 EA. 6-VOLT BATTERIES OR USE VEHICLE POWER WITH THE APPROPRIATE POWER CABLE. INSURE THAT BATTERIES ARE 4.5-6.5 VOLTS OR THAT YOU HAVE A GOOD POWER CONNECTION WITH THE SLAVE CABLE CONNECTOR.

  1. RUN A BUILT-IN-TEST
  2. OBSERVE THAT THE FOLLOWING EVENTS OCCUR:
  1. SONAR ALERT WILL BEEP ONCE.
  2. STROBE LIGHT WILL FLASH ONCE DISPLAY WILL READ "0000" AND SCROLL THROUGH ALL NUMBERS TO "9999".
  3. AFTER ONE SECOND A TWO DIGIT OR FOUR DIGIT CODE WILL DISPLAY.

NOTES: DETECTORS ON SDA WILL NOT WORK WHEN USING DETECTOR ARRAY CABLE.

IF YOU RECEIVE A 01 CODE WHEN USING VEHICLE POWER, CHECK VEHICLE VOLTAGE GAUGE INSURE THAT IT IS IN THE GREEN BAND THEN CHECK POWER CONNECTORS.

WHEN THE MITS IS HIT AND KILLED THE SONAR ALERT WILL BEEP FOR 30 SECONDS AND STOP, THE STROBE WILL CONTINUE TO FLASH UNTIL THE SYSTEM IS RESET.



BIT TEST READINGS

chart.gif - 30.10 K


MILES MITS ELECTRONIC CONTROL UNIT (ECU)

  1. Power Switch
  2. Controller Key Switch
  3. Mode Select Switch
  4. Detector Array Connector
  5. Interface Cable Connector
  6. Sonalert
  1. Strobe/Detector Array Cable Connector
  2. RS232 interface Connector
  3. Power Cable Connector
  4. Update display Switch
  5. Display
img56.gif - 37.02 K

ENABLE THE MITS KIT TO PORTRAY A TARGET FOR MILES WEAPONS PRACTICE/BORESIGHT AT HOME STATION (TARGET #3 - ADMIN/LOG TARGET TYPE).

AFTER YOU POWER UP AND RUN A BIT TEST INSERT THE CONTROL KEY INTO THE KEY SWITCH (2) AND TURN ON (LEAVE IT ON). PRESS THE UPDATE SWITCH FOR 3-5 SECONDS AND THE #0001 WILL START TO SCROLL 1-4. STOP AT #3. TURN THE CONTROL KEY BACK AND TAKE IT OUT.



MITS KIT

1. Install one 12 volt Lithium battery.

  1. Place battery into battery pouch.
  2. Connect pigtail adapter into the battery.

Display shall read

ENCODER OK
DECODER OK

Followed by two alternating flashing messages which should read

VEHICLE POWER
REQUIRED
KILL BY SYSTEM
POWER ON

2. MITS kits will plug in their slave cables, or connect the J6 on the console.

The system will automatically run a BIT test. Display will read

STANDBY NOW
RUNNING BIT TEST

Note: If the VDD displays following messages:

ALERT REPLACE
MILES-2 BATTERY

Proceed with the next step.

3. MITS kits will UNPLUG their slave recepticles.

4. Install a fresh lithium battery.

Follow steps one and two above with new battery.

Hull to Turret Transmitter
Table of Contents
Audio Visual Cue (A/V Cue)



NEWSLETTER
Join the GlobalSecurity.org mailing list


One Billion Americans: The Case for Thinking Bigger - by Matthew Yglesias