APPENDIX B

TRAINING DEVICES AND AIDS

Training devices and training aids enable soldiers to learn as much as they can about a weapon before they try the real thing. This saves money and time, and it prevents injuries. Training devices both look and behave like the real weapon, but are cheaper and safer to practice with. Training aids include anything else used to help soldiers learn to use a weapon. Trainers should use their imaginations and invent or adapt other training aids from available resources.

NOTE: The local Training Support Center (TSC) can install the conversion kits, but DOD Regulation 5100.76-M requires that all sensitive conventional arms, ammunitions, and explosives, including expended launchers, be carefully controlled.

Figure B-1. LAW subcaliber trainer.

Figure B-2. M190 subcaliber conversion kit.

a. Technical Data.

(1) Technical data for the M73 35-mm subcaliber practice rocket are as follows:

Length................... 22.48 cm (8.86 inches)

Diameter................. 3.51 cm (1.38 inches)

Weight................... 154 grams (5.39 ounces)

Range.................... 10 to 250 meters (9.14 to 228.5 yards)

Propellant Charge........ 3 tubular grains of M7

Spotting Head Charge..... .05 ounce (1.5 grams) of composition mix M80

(2) Technical data for the assembled M190 practice rocket launcher are as follows:

Diameter of launcher..... 12.45 cm (4.9 inches)

Diameter of rocket tube.. 3.56 cm (1.4 inches)

Weight (with rocket) .... 2.26 kg (5.02 pounds)

Length of launcher

-Extended............... 89.9 cm (35.4 inches)

-Collapsed.............. 64.26 cm (25.32 inches)

Sights................... Open, temperature compensating

b. Trigger. This is the same as for the LAW.

c. Sights. These are the same as for the LAW.

d. Operation. The LAW subcaliber training device operates the same as an M72-series LAW. After the M190 has been loaded, it may remain closed, or it can be extended and fired. Either way, the procedures are the same as those for the LAW.

CAUTION
WHEN LOADING THE LAW SUBCALIBER TRAINER, ENSURE THE REAR COVER IS OPEN, THE SLING ASSEMBLY IS OFF, AND THE LAUNCHER IS COLLAPSED.

e. Loading. To load the M73 rocket into the M190 launcher (Figure B-3)--

(1) Twist and remove the primer housing lockpin and open the primer housingdoor.

(2) Remove the fired primer block (if present) from the primer block cavity of the launcher.

(3) Inspect the primer block cavity for obstructions such as primer case stuck on the firing pin.

(4) Pivot and remove the safety clip from the rocket.

(5) Insert the M73 rocket into the launcher with the primer face up and toward the firing pin housing.

(6) Guide the primer block into the primer block cavity with the primer toward the front of the launcher. Close the primer housing door, insert the lockpin across the primer housing door, and twist to ensure a spring-tight fit. Ensure the primer housing door fits snugly.

Figure B-3. Loading the LAW subcaliber launcher.

f. Unloading. To unload the M73 rocket from the M190 launcher--

(1) Return the arming handle to SAFE.

(2) Remove the weapon from your shoulder, keeping the weapon pointed downrange.

(3) Partly collapse the launcher, and remove the primer housing lockpin.

(4) Open the primary housing door, and remove the primer from its housing.

(5) Remove the rocket.

(6) Replace the safety clip on the rocket.

(7) Place the rocket in its original container.

g. Function. The M73 rocket launches the same as tactical rocket, but when the rocket head strikes the target, it sets off the spotting head that produces a flash, noise, and white smoke.

CAUTION
THE M73 SUBCALIBER ROCKET OPERATES BETWEEN -23 AND 60°C (-10 AND 140°F). FIRE IT ONLY WITHIN THIS TEMPERATURE RANGE.

h. Misfire Procedures. These are the same as for the M-72 series LAW.

i. Range Procedures and Safety. These procedures are the same as for the LAW. The training device can be used against all solid stationary or moving targets. However, because the subcaliber rocket can penetrate 0.124 inches (0.315 cm) of steel plate or 8 inches (20.32 cm) of soft wood, the target should be constructed of 3/16-inch steel plate backed by 3/4-inch plywood.

j. Combat Techniques. These are the same as for the LAW.

Figure B-4. Using GTA 7-2-5 with target silhouette sheet and front sight template.

• Inspect the AT4 for serviceability.
• Prepare an AT4 for firing.
• Demonstrate the correct AT4 firing position.
• Perform misfire procedures.
• Return an AT4 to carrying position.

Figure B-5. M287 subcaliber tracer trainer.

a. Description. The M287 tracer trainer is a specially constructed AT4. Unlike the LAW subcaliber trainer, it is not made from an expended launcher, so it has its own NSN. It is designed to accept a special rifle barrel that fires a reduced-load 9-mm cartridge.

(1) The M287 may be fired at stationary or moving targets. Before it can be fired at a target tank occupied by personnel, the parts of the tank that could suffer damage must be shielded. The local TSC can provide specifications for modifying tanks to be used as targets for the M287 tracer trainer.

(2) Unlike the M136 AT4 itself and the FHT, the M287 has no band between the front and rear sights. The trainer has a 9-mm submachine gun barrel, a breach assembly, and a bolt (Figure B-6). The bolt is easily removed to load the 9-mm cartridges and to inspect the barrel for obstructions.

Figure B-6. M287 barrel assembly and components.

(3) If the M287 tracer trainer is damaged, the unit armorer can replace its complete firing mechanism, firing rod, bolt, sights, sling, and 9-mm barrel assembly (Figure B-7).

Figure B-7. Replaceable parts for the M287 tracer trainer.

b. Technical Data. The following technical data apply to the M287 subcaliber tracer trainer:

Length................... 1,020 mm (40 inches)

Weight................... 7 kg (15 pounds)

Action .................. Mechanical

Sights:

-Front ................. Three-post system
-Rear................... Adjustable range, with two peepholes:
--2-mm peephole for daylight and 7-mm peephole
--for limited visibility

Operating temperature ... 10° to 27°C (0° to 100°F)

Muzzle velocity.......... 300 mps (984 fps)

Caliber ................. 9 mm

c. Ammunition. The M939 9-mm tracer cartridge has a lighter powder charge than a standard 9-mm bullet. The lighter charge enables the cartridge to closely duplicate the trajectory of the AT4 tactical round at ranges out to 700 meters. The M939 cartridge also has a tracer element to enable the firer to compare the impact of the cartridge with the sight picture. The firer can see the tracer out to 550 meters. Firing the M287 tracer trainer helps the firer learn the correct sight picture for moving targets. The cartridge's red tip and half-black base (Figure B-8) distinguishes it from standard 9-mm ammunition, which should never be fired from the M287 tracer trainer.

Figure B-8. M939, 9-mm tracer cartridge.

d. Function Check. Before the M287 is fired, a function check must be performed to ensure the trigger and safety mechanisms are operating properly. Function check procedures are shown in Table B-1. However, before performing a function check, ensure--

• The cocking lever is in the safe ("S") position.

• The transport safety pin is fully inserted, with the lanyard wrapped clockwise around the launcher.

• The bolt is removed from the breech.

Table B-1. Function check, M287 tracer trainer.

WARNING
LOAD LIVE AMMUNITION ONLY ON THE FIRING LINE. NEVER FIRE THE M287 TRACER TRAINER AT HARD TARGETS LESS THAN 125 METERS FROM THE FIRING LINE. REMAIN CLEAR OF THE FRONT OF THE M287, WHICH MUST BE POINTED DOWNRANGE AT ALL TIMES.

e. Loading. The M287 tracer trainer is loaded as follows:

(1) The firer performs the function check and places the M287 tracer trainer on his shoulder.

(2) The trainer looks through the barrel from the rear to verify that it contains no obstructions. He inspects the cartridge primer to ensure it is not dented, inserts the bolt into the breech (Figure B-9), and presses in and turns the bolt clockwise to the "S" to place it in the safe position (Figure B-10). Then he arms the tracer trainer by turning the bolt clockwise to "F" so that it can be fired (Figure B-11).

(3) With the launcher still on his shoulder, the firer cocks the launcher by placing the cocking lever in the cocked position.

Figure B-9. Inserting bolt with cartridge into the breech of the M287 tracer trainer.

Figure B-10. Ensuring tracer trainer bolt is in the safe position.

Figure B-11. Arming the tracer trainer.

f. Unloading. With the tracer trainer still on the firer's shoulder, the trainer or instructor removes the bolt by turning it counterclockwise past the "S," then pulling the bolt from the breech (Figure B-12). If more rounds are to be fired, he removes the expended cartridge and reloads the bolt.

Figure B-12. Unloading the tracer trainer.

g. Reloading. With the tracer trainer still on his shoulder, the firer places the cocking lever in the safe position, keeping the tracer trainer on his shoulder and pointing toward the target. The trainer reloads the tracer trainer and prepares it for firing.

h. Misfire Procedures. In the event of a misfire--

(1) Immediately shout "Misfire!"

(2) Release the forward safety, recock the launcher, and ensure the cocking lever is erect. Fully depress and hold down the forward safety, then aim and press the red trigger button.

(3) If the tracer trainer still fails to fire, repeat the two previous steps.

(4) If the launcher fails to fire again, release the forward safety, maintain your firing position, and return the cocking lever to the safe position.

(5) Notify the training supervisor.

(6) If a real misfire occurs that cannot be corrected by following the steps previously discussed, the trainer or assistant trainer on duty must ensure the cocking lever is in the safe position and that the forward safety is in the vertical position. He must then insert the transport safety pin and remove and inspect the cartridge. If the primer is dented, he replaces it, disposing of the old one IAW range safety SOP. If the primer is not dented, he notifies DS maintenance to inspect the bolt firing pin for damage. He then reloads the tracer trainer and continues the training exercise.

i. Range Procedures and Safety. These are the same as for the M136 AT4.